With wifi + Starlink + cellular as uplinks, the onboard GbE earns its keep
as a wired LAN port instead of the metric-150 ethernet WAN: eth0 leaves
netplan/NM (added to van-ap-unmanaged.conf) and joins br0 via networkd
(23-van-lan-eth0.network), so wired clients get 10.42.0.x DHCP/DNS and NAT
exactly like Wi-Fi clients. The eth WAN is gone from van-failover's config.
Cutover notes: delete the old netplan-eth0 / stray eth0 NM profiles, then
nmcli general reload + networkctl reload/reconfigure eth0. NEVER cable this
port (or the USB LAN dongle) back into an upstream LAN — dnsmasq on br0
would serve rogue DHCP there; STP stays off, so don't cable both wired LAN
ports to the same switch either.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Second radio (wlxd8ec5e2faa8c, RTL8822BU/rtw88), same VanLink SSID+PSK,
ch6 HT20, bridged into br0 next to the 5GHz AP. Runs as its own hostapd
instance + own watchdog so a USB wedge on one radio never darkens the
other; van-ap-watchdog now takes conf path + unit name as args (defaults
unchanged). rtw88.conf disables deep power-save (rtw89 gotcha analog)
and the driver's USB2->3 self-upgrade (USB3 noise in the 2.4GHz band —
note: dongle currently sits in a USB3 port, so it still enumerates
SuperSpeed; move to a USB2 port if 2.4GHz range disappoints).
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Add a wired LAN port on the same 10.42.0.0/24 segment as VanLink WiFi by
bridging both into br0. The gateway IP, dnsmasq, and NAT move off the wlan name
onto br0; hostapd (not networkd) enslaves the wlan via bridge=br0, since a
station-mode wlan can't be bridged until it's in AP mode. NM leaves the wired
port unmanaged so networkd owns it. Failover/Starlink (enxd8ec5eeb3512)
untouched.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
Andreas WredeandClaude Fable 5