Problem: R5C spontaneously rebooted due to hardware watchdog timeout
Cause 1: van-gps-owntracks in infinite restart loop (MQTT connect failed)
Cause 2: mosquitto only listening on localhost, so clients couldn't connect
Solution:
- Add restart limits to van-gps-owntracks and van-li3-battery services
(max 3 restarts per 5 minutes prevents infinite restart loops)
- Configure mosquitto to listen on all interfaces (0.0.0.0:1883)
- Deploy mosquitto listener config via deploy.sh
- Restart mosquitto during deploy to apply config changes
This prevents the system from hitting the 11-second hardware watchdog timeout
when services crash and systemd auto-restarts them indefinitely.
Co-Authored-By: Claude Haiku 4.5 <noreply@anthropic.com>
With wifi + Starlink + cellular as uplinks, the onboard GbE earns its keep
as a wired LAN port instead of the metric-150 ethernet WAN: eth0 leaves
netplan/NM (added to van-ap-unmanaged.conf) and joins br0 via networkd
(23-van-lan-eth0.network), so wired clients get 10.42.0.x DHCP/DNS and NAT
exactly like Wi-Fi clients. The eth WAN is gone from van-failover's config.
Cutover notes: delete the old netplan-eth0 / stray eth0 NM profiles, then
nmcli general reload + networkctl reload/reconfigure eth0. NEVER cable this
port (or the USB LAN dongle) back into an upstream LAN — dnsmasq on br0
would serve rogue DHCP there; STP stays off, so don't cable both wired LAN
ports to the same switch either.
Co-Authored-By: Claude Fable 5 <noreply@anthropic.com>
Add a wired LAN port on the same 10.42.0.0/24 segment as VanLink WiFi by
bridging both into br0. The gateway IP, dnsmasq, and NAT move off the wlan name
onto br0; hostapd (not networkd) enslaves the wlan via bridge=br0, since a
station-mode wlan can't be bridged until it's in AP mode. NM leaves the wired
port unmanaged so networkd owns it. Failover/Starlink (enxd8ec5eeb3512)
untouched.
Co-Authored-By: Claude Opus 4.8 <noreply@anthropic.com>
andreasandClaude Sonnet 5
Andreas WredeandClaude Fable 5