andreasandClaude Haiku 4.5
2b00157642
Problem: RTL8822CE driver caused kernel panic (watchdog hard LOCKUP) when hostapd tried to use VHT 802.11ac with 80MHz channel width on channel 149. Root cause: Driver/firmware instability with VHT capabilities on this chip. Solution: Disable VHT, use HT40+ (802.11n) only. - Removes ieee80211ac (VHT), ieee80211ax (802.11ax), and 80MHz channel width - Keeps HT40+ with Short GI for reasonable performance - Stable operation on channel 149 (5745 MHz) This allows the 5GHz AP to start and beacon without lockup on R5C hardware. Co-Authored-By: Claude Haiku 4.5 <noreply@anthropic.com>
33 lines
1.0 KiB
Plaintext
33 lines
1.0 KiB
Plaintext
interface=@WIFI_5G_IFACE@
|
|
# Put the AP into br0 so Wi-Fi and the wired LAN port share one 10.42.1.0/24 segment.
|
|
# hostapd adds the wlan to the bridge after setting AP mode; the bridge itself + its
|
|
# wired member + the gateway IP are defined under /etc/systemd/network (2x-van-br0/lan).
|
|
bridge=br0
|
|
# Control socket so van-ap-watchdog (and hostapd_cli) can read the AP's real state
|
|
# (state=ENABLED means it's actually beaconing) — used to detect a wedged radio that
|
|
# stays "running" but stops serving after a USB glitch.
|
|
ctrl_interface=/var/run/hostapd
|
|
driver=nl80211
|
|
ssid=VanLink2
|
|
country_code=CA
|
|
ieee80211d=1
|
|
ieee80211h=0
|
|
hw_mode=a
|
|
channel=149
|
|
wmm_enabled=1
|
|
ieee80211n=1
|
|
ht_capab=[HT40+][SHORT-GI-20][SHORT-GI-40]
|
|
# Disabled: VHT/80MHz causes RTL8822CE driver lockup on channel 149
|
|
# ieee80211ac=1
|
|
# vht_oper_chwidth=1
|
|
# vht_oper_centr_freq_seg0_idx=155
|
|
# vht_capab=[RXLDPC][SHORT-GI-80][SU-BEAMFORMEE]
|
|
# ieee80211ax=1
|
|
# he_oper_chwidth=1
|
|
# he_oper_centr_freq_seg0_idx=155
|
|
auth_algs=1
|
|
wpa=2
|
|
wpa_passphrase=1foot11foot11
|
|
wpa_key_mgmt=WPA-PSK
|
|
rsn_pairwise=CCMP
|